A-A-50730A
2.2.2 Radio frequency interference (RFI) capacitors. Any capacitor used in RFI filters shall be rated for at least four (4) times the operating voltage.
2.3 Design and construction. Unless otherwise specified herein, the equipment shall comply with the Class III design and construction requirements of MIL-PRF-28800. The equipment shall be of solid-state construction.
2.4. Type of construction. Construction of the generator shall be of a monolithic design.
2.4.1 Signal input and output connectors. Unless otherwise specified, all signal input and output connectors shall be type BNC female, except for RF output connector(s) which may be type N.
2.4.2 Electrical power sources. The equipment shall operate from nominal commercial, military, and shipboard power sources of 100, 120, 220 and 240 volts AC (+10%) at line frequencies of 50 Hz to 60 Hz.
2.4.3 Electrical power connectors. The equipment shall operate with a single phase input with a ground on either side.
2.4.4 Power consumption. Maximum power consumption shall not exceed 450 volt amperes V.A.
2.4.5 Fuses. Fuse(s) shall be provided, on the exterior rear panel for replacement without entering the enclosure. The fuse(s) shall automatically disconnect the equipment from the power source in the event of excessive current requirements.
2.4.6 Surge and transient voltage protection. The generator shall contain surge and transient voltage protection internal of the enclosure. The transient voltage protection circuit shall be so designed as to prevent electronic device damage within the system. The surge voltage protection circuit shall conform to IEEE Std 587-1980.
2.4.7 Dimensions and weight.
2.4.7.1 Equipment dimensions. The maximum dimensions for the generator should be approximately 9 inches height x 17 inches wide x 24 inches deep.
2.4.7.2 Equipment weight. The weight including all accessories (excluding manual) shall not exceed 90 lbs.
2.4.8 Rackmount. Rackmount capability shall be available as an option for the equipment specified herein.
2
For Parts Inquires submit RFQ to Parts Hangar, Inc.
© Copyright 2015 Integrated Publishing, Inc.
A Service Disabled Veteran Owned Small Business