A-A-50740 Spectrum Analyzer 10 Khz - 50 GhzThis Commercial Item DescriptionCID describes a solid-state, internal pre-selection, programmable, 10 Hz resolution bandwidth, 10 kHz to 50 GHz, Spectrum Analyzer including external mixers. This CID is meant as a minimum requirement for the Spectrum Analyzer in which only those manufacturers that meet or surpass the following requirements are qualified per this CID. Test equipment offered may be commercially available and may be modified to the extent necessary to meet the following requirements are supplied per this CID.

Pages 1 - 2 - 3 - 4 - 5 - 6 - 7

A-A-50740A

3.7.37 Accessories. Each instrument shall be provided with the following:

a. Spare fuses

b. 115V power cable c. Operator manual

d. Programmer manual

e. 18 - 26.5 GHz mixer (if needed to meet specifications)

f. 26.5 - 40 GHz mixer g. 33 - 50 GHz mixer

h. Mixer amplifier (if required)

i. N male to BNC female adapter

j. BNC to BNC connector, 50 ohm coax cable k. 2 meter, double shielded GPIB cable

3.7.38 Dimensions and Weight. The size and weight of the Spectrum Analyzer shall be consistent with current commercial practices.

4. REGULATORY REQUIREMENTS.

4.1 The offeror/contractor is encouraged to use recovered materials to the maximum extent practicable, in accordance with paragraph 23.403 of the Federal Acquisition Regulation (FAR).

5. PRODUCT CONFORMANCE PROVISIONS.

5.1 Product Conformance. The products provided shall meet the salient characteristics of this CID, conform to the producer's own drawings, specifications, standards and quality assurance practices, and be the same product offered for sale in the commercial market. The government reserves the right to require proof of such conformance.

5.2 Metric Products. Products manufactured to metric dimensions will be considered on an equal basis with those manufactured using inch-pound units, provided they fall within the specified tolerances using conversion tables contained in the latest revision of Federal Standard No. 376, and all other requirements of this CID are met. If a product manufactured to metric dimensions exceeds the tolerances specified in the inch/pound units, a request should be made to the contracting officer to determine if the product is acceptable.

6. PACKAGING.

6.1 Preservation, packing, and marking shall be as specified in the contract or order.

7. NOTES.

7.1 Source of documents.

7.1.1 Military Specifications, Standards, and Handbooks referenced herein may be obtained at https://assist.daps.dla.mil or from the Standardization Documents Order Desk, 700 Robbins Ave, Bldg 4, Section D, Philadelphia, PA 19111-5094.

7.1.2 The Federal Acquisition Regulation (FAR) may be obtained at www.acqnet.gov/far or from the Superintendent of Documents, U.S. Government Printing Office, Washington, DC, 20402.